Nimco

EPC100

The EPC100 is a single-axis analogue control joystick. The operating principle is non-contacting rotating magnetic field over hall-sensor and it is short circuit proof.


AxisSingle
Angular Operating Range▒20░


EPC300

The EPC300 is a two-axis analogue control joystick. The operating principle is non-contacting rotating magnetic field over hall-sensor and it is short circuit proof.


AxisDouble
Angular Operating Range▒20░
Buttons1-3 push buttons


EPC350

The EPC350 is a three-axis analogue control joystick .The operating principle is non-contacting rotating magnetic field over hall-sensor.


Axis3
Angular Operating Range▒20░ X and Y, ▒30░ Z


EPC700

The EPC700 is a two axis heavy duty analogue control joystick. The operating principle is non-contacting rotating magnetic field over hall-sensor and it is short circuit proof.


AxisDouble
Angular Operating Range▒25░ in both directions
Optionson/off push buttons, thumb wheel potentiometers


EDB 8-64

The EDB 8-64 is a robust I/O module with 8 PWM outputs, programmable through the Windows based Nimco EasyProg software. It can be used to control up to 8 proportional solenoids and has a CAN-bus interface. All PWM outputs have a current feedback to compensate for varying coil resistance due to heating of the solenoid valves.


EDB 16-64

The EDB 16-64 is a robust I/O module with 16 PWM outputs, 8 balanced analogue inputs and one digital relay output. It has a CAN-bus interface and is programmable through the Windows based Nimco EasyProg software. All PWM outputs have a current feedback to compensate for varying coil resistance due to heating of the solenoid valves


CC8

The CC8 Control Card is an analogue joystick circuit board that is designed to fit underneath most joysticks with its small circular build dimensions. It has 8 balanced analogue inputs for use together with any 2-axis joystick and a CAN-bus interface to connect to other modules. It is programmable through the Windows based Nimco EasyProg software.


EasyProg

Nimco EasyProg is an easy-to-use, Windows based software for programming the different Nimco CAN-bus modules. The interface is based on logic programming and uses Boolean operators to define the program instructions. Basically no programming experience is needed to start building programs in EasyProg.